Can I Install EPDM Onto PVC / Plastic?

No, unfortunately ClassicBond EPDM cannot be used to overlay existing PVC/Plastic surfaces. 

You can join ClassicBond membranes to adjoining PVC/Plastic roof's however, this would be done using 6 inch Cover Tape and Primer.

Below is a list of the surfaces ClassicBond EPDM can be overlays onto: 

Bonding Surface Adhesive
Timber Under 100sqm Water Based Adhesive
Timber Over 100sqm  Contact Adhesive or Spray Contact
Glass Contact Adhesive or Spray Contact
GRP Contact Adhesive or Spray Contact
Tissue Faced Insulation Contact Adhesive or Spray Contact
Metal Contact Adhesive or Spray Contact
Concrete  Contact Adhesive or Spray Contact

If you have any further questions about this or anything else please send us an email to office@rubber4roofs.co.uk or give us a call on 02477590349.

Did this answer your question? Thanks for the feedback There was a problem submitting your feedback. Please try again later.