Can I Install ClassicBond EPDM Onto Metal?

Yes ClassicBond EPDM can be installed onto metal but contact adhesive must be used for the entire roof surface not just the perimeter. 

ClassicBond EPDM can also be used on the following substrates:  

Substrate Adhesive
Timber Under 100sqm Water Based Adhesive
Timber Over 100sqm  Contact Adhesive or Spray Contact
Glass Contact Adhesive or Spray Contact
GRP Contact Adhesive or Spray Contact
Tissue Faced Insulation Contact Adhesive or Spray Contact

If you have any further questions about this or anything else please send us an email to office@rubber4roofs.co.uk or give us a call on 02477590349.

Did this answer your question? Thanks for the feedback There was a problem submitting your feedback. Please try again later.