ClassicLiquid Reinforcing Fabric

General Information

  • ONLY USED for built-up felt & asphalt substrates.
  • ClassicLiquid Reinforcing Fabric is applied between two coats of ClassicLiquid Waterproof Coating
  • Sold in 25sqm rolls.

Application onto Felt and Asphalt

  • Apply ClassicLiquid Waterproof Coating and Reinforcing Fabric wet on wet to the previously primed, clean, dry surface with rollers or brushes
  • ClassicLiquid Reinforcing Fabric is then immediately pressed into the wet liquid ensuring that there are no creases or trapped air.
  • The second coat of ClassicLiquid Waterproof Coating is immediately applied over the saturated fabric.
  • Overlap adjacent runs of Reinforcing Fabric a minimum of 50mm.
  • Although the product will cure in 4-6 hours temperature dependant do not traffic the roof until the product is fully cured. (This is normally after 48 hours)
  • Do not exceed 48 hours between coats. If this period has been exceeded then a coat of ClassicLiquid Primer must be applied, allow to fully cure and then the subsequent coating can be applied.
  • https://www.rubber4roofs.co.uk/shop/classic-liquid-reinforcing-fabric
Did this answer your question? Thanks for the feedback There was a problem submitting your feedback. Please try again later.