ClassicLiquid Primer

What can ClassicLiquid Primer be applied onto?

Asphalt
Build up felt
Ceramic Tiles
OSB Decking and all other Timber surfaces
Recovery Boards
GRP
Metal
As a “reactivation primer“ over ClassicLiquid Waterproof Coating and ClassicLiquid Detail Coating if these products require over coating after the 48 hours cure time has been exceeded.
As a sealer over concrete block.
Covers approximately 20m2.

Features & Benefits

Single component (No accelerator needed)
Low viscosity (Meaning the primer is thin and not thick)
Easily applied with a brush or roller
Excellent wetting, penetration and drying times. (Approx two hours but dependant on the weather and humidity)
Dries off in approx 2 hours dependant on the weather.

Application Procedure

The intended substrate which the primer is being applied to MUST be thoroughly cleaned beforehand. This can be done with a high pressure washer, on smaller areas a stiff broom and soapy water and rinse will suffice. Remove all oil, grease and wax contaminants, cement laitance and loose particles. Make good all cracks and blisters, fill surface irregularities with a suitable product. Allow to fully dry.
Apply ClassicLiquid Primer at a sufficient coverage rate to seal the surface.
Primer coverage rates will vary dependant on surface porosity.
Allow primer coat to fully dry. This takes around 2 hours depending on air temperature and humidity.